BarracksSi
Senior Member
- Joined
- Apr 1, 2017
- Threads
- 13
- Messages
- 2,188
- Reaction score
- 1,298
- Location
- DC
- Vehicle(s)
- '17 Civic Sport Touring Hatch; '17 CR-V EX. Formerly '02 EP3.
I would bet that you should not use ball seat lug nuts on those wheels.Its same 16" drag dr-69
The thread pitch given is correct -- 12mm x 1.5 -- and the other specs can vary (I've used lug nuts that needed a 17mm socket before; plus you can get all those spline-type nuts, and Mugen made 7-sided nuts, too). But make sure that the seating area of those wheels' lug holes matches the lug nuts.
I'm telling you this because I don't want you to damage your wheels by using the wrong nuts.
[edit -- I re-read your original question; if all you needed to know was the thread pitch, then kwk1 gave you the right specs. I didn't want you (or any other readers) to think that 'ball seat' was also required for your aftermarket wheels]
(btw -- we really need a comprehensive, but readable, FAQ/Wheels101 sticky thread)
Sponsored
Last edited: