Sport-injected... Build Thread

[gtman]

Scott, your car is exceptional. Out of curiosity what did you torque the bar to?

Sponsored

 

[Sport-injected]

Scott, your car is exceptional. Out of curiosity what did you torque the bar to?

Thank you! I appreciate that. The ultra racing bar? 90nm. I went off of the magic collar torque spec since it mounts at the same spot.

 

[Sport-injected]

Changed the oil today, went back to good ol mobil 1 0-40, wix xp filter. Inspected the Maperformance oil cooler lines, no rubbing no leaks. Pulled a sample for Blackstone.

 

[websitesdown]

Changed the oil today, went back to good ol mobil 1 0-40, wix xp filter. Inspected the Maperformance oil cooler lines, no rubbing no leaks. Pulled a sample for Blackstone.

How are you getting it up on all for stands?

 

[Sport-injected]

How are you getting it up on all for stands?

I jack the front up first from the subframe, then set it down on 2 stands. Then jack the rear up from the jack point in the middle of the rear subframe to the left of the exhaust pipe. All jack stands are at the jacking point under the side skirts.

 

[chrisvwpw]

@Sport-injected can you give a full run down of what you have for you suspension? I’m currently starting to upgrade mine. I have eibach pro kit springs, 27won front strut bar and rv6 rear sway bar. What would you suggest would be next in line? Trying to set it up for track days.

 

[Sport-injected]

@Sport-injected can you give a full run down of what you have for you suspension? I’m currently starting to upgrade mine. I have eibach pro kit springs, 27won front strut bar and rv6 rear sway bar. What would you suggest would be next in line? Trying to set it up for track days.

Platinum pearl white

-Engine
Prl cobra cold air intake - race MAF
PRL titanium turbo inlet pipe
Vargas GC turbo - outlet match ported to prl inlet pipe
Prl catless downpipes 3"
Maperformance front pipe
Maperformance "street" exhaust 3"
Hasport full motor mount kit 85a - rear/left side/right side
Prl full intercooler kit
Blox 58mm throttle body
Skunk 2 intake manifold
Ktuner V2
Custom etune - IMW
MSD coils
Mobil 1 0-40
K&N hp-1010 filter
PLM catch can
Skunk 2 stage 2 cams and high lift springs (not installed)

-Drivetrain
Competition stage 2 clutch
Competition 22lb flywheel
Acuity full adjustable shifter
Acuity shifter cable bushing
Kzcmc
Slave cylinder delay valve delete
Redline trans fluid
Prl braided clutch line

-Suspension/chassis
Silvers double adjustable coilovers
-swift 10k front springs
-Eibach 10k rear springs
Whiteline 27mm front swaybar kit
Karcepts rear sway bar
RV6 rear camber arms
RV6 front compliance bushing kit
RV6 rear knuckle spherical bushings
PowerFlex front control arm forward bushing
Eibach front sway bar endlinks
Eibach rear swaybar reinforcement kit
Ultra-racing front 2 point frame brace
Ultra-racing mid 3 point frame brace
Ultra-racing strut tower bar
Ultra-racing rear 2 point frame brace
Skunk2 rear camber arms
Magic collar rigid subframe collars
PLM adjustable ball joints


-Braking
Wildwood narrow lite 6 piston BBK front
Carbotech xp12 front pads
EBC rear v-slot rotors
Carbotech xp10 rear pads
Goodridge braided brake lines rear
Redline R700 brake fluid

-Exterior
Gram lights 57cr with kumho ecsta V730 (track setup)
Aohdan DS06 wheels with Bridgestone potenza S04 tires (street setup)
Bridgestone blizzak on stock wheels
HFP side skirts
2020 Si front bumper garnish
HIC rear window spoiler
Weather tech window vents
Trunk lid lip spoiler
HID low beams 6000k
LED high beams
LED fog lights
Full ceramic coating
American modified grill

-Interior
Weather tech floor mats front/trunk
Brushed metal dash trim
Acuity/Perrin/raceng/typeR shifters
Acuity adjustable gas pedal mount
Sparco r100 seats
Schroth Profi II harnesses

-Cooling
MAPerformance oil cooler
Koyorad radiator
Mishimoto radiator
hoses
Spoon 160° thermostat
DEI downpipe wrap
DEI gold heat tape
PTP turbo blanket

That's the full list, a couple things not installed yet. RV6 compliance bushings or whiteline ALK will help with suspension for sure, I currently have the white line kit installed but will replace with RV6 compliance bushings soon. Wunderladen racing so has a kit similar to white line.

 

[Supertech128]

Has anyone found a brand that sells red calipers for a ‘19 Si? I cannot find a single one that sells calipers red from factory. I was hoping Powerstop would have them but not luck anywhere.

 

[dt10g]

Has anyone found a brand that sells red calipers for a ‘19 Si? I cannot find a single one that sells calipers red from factory. I was hoping Powerstop would have them but not luck anywhere.

I'd be inclined to choose the calipers you want and then just have them powder-coated red.

Have you checked out KTuned?
you can get those in anodized or powder coated red

https://k-tuned.3dcartstores.com/Big-Brake-Kit_p_2180.html

I'm pretty sure they have something appropriate for your car
... if you contact them, they can advise you best on the right configuration

 

[Sport-injected]

The 10k springs and rear subframe brace have made a noticeable difference in rotation throughout the entire turn. Especially low speed, the rotation feels effortless and the back end feels solid. That's just driving through my neighborhood, can't wait for the track!!! At high speeds the back end feels more bouncy from the stiffer springs, I haven't messed with the shock tuning at all yet. That will be next weekend.

 

[chrisvwpw]

Have you installed the cusco x-brace yet?

 

[Sport-injected]

Have you installed the cusco x-brace yet?

Not yet. Hopefully this week.

 

[Sport-injected]

Installed the Ultra Racing mid chassis brace last night. This is for FK chassis not FC. I needed to drill 2 holes, installed threaded rivet nuts for 8mm hardware to make it work. Utilized the 2 6mm bolts used for the heat shield and the 2 added 8mm bolts. Left car up in the air as I will install the Cusco X brace today

 

[Sport-injected]

Cusco X-brace installed along with the Ultra Racing center brace. Next up is the RV6 compliance bushing, but not this weekend. I did have to cut the last 1/3 of the underbody covers because of the X brace.