Rear braces for Si coupe?

[REBELXSi]

I haven't seen any and I hear the rear end my coupe creaking over uneven surfaces like my driveway.

Sponsored

 

[gtman]

These should satisfy your desire for something stiff in your rear end.

https://ultraracing-usa.com/honda-civic-fc-2016-2019-rear-torsion-2-points/

https://www.maperformance.com/colle...016-2019-honda-civic-non-type-r-3c3-492-rmlhd

 

[REBELXSi]

These should satisfy your desire for something stiff in your rear end.

I don't think the UR one fits the coupe. I'll check out the other one

 

[gtman]

I don't think the coupe and sedans have different rear chassis/suspension/subframe setups do they?

 

[REBELXSi]

I don't think the coupe and sedans have different rear chassis/suspension/subframe setups do they?

Tbh, I'm not sure. I just remember when I bought my UR strut bar, I was on their site and they said their rear bar wasn't compatible with the coupe.

 

[Maroco]

My type r subframe brace stopped all creaking from my trunk are when going up the initial angle of my driveway.... Almost sounded like dry poly bushings

Cusco offers some rear and from bracing though http://blog.cuscousainc.com/honda-civic-type-r-cusco-parts-list/

 

[MeanGreenSi]

The ultra bracing brace fits the coupe with the factory exhaust. I have the the GReddy SP exhaust and had to remove the brace when I installed the exhaust.

 

[Yonder]

The ultra bracing brace fits the coupe with the factory exhaust. I have the the GReddy SP exhaust and had to remove the brace when I installed the exhaust.

Well this is good to know!

 

[PowerPerLiter]

The ultra bracing brace fits the coupe with the factory exhaust. I have the the GReddy SP exhaust and had to remove the brace when I installed the exhaust.

Would you like to get rid of the brace? PM me.

Sponsored