Raziate
New Member
- First Name
- Mike
- Joined
- Oct 11, 2018
- Threads
- 3
- Messages
- 4
- Reaction score
- 7
- Location
- California
- Vehicle(s)
- 2016 Honda Civic Lx
- Thread starter
- #1
So I recently just installed a Sony XAV-AX100 Stereo Receiver in my 2016 Honda Civic LX, I purchased the setup with the harness pre-wired by Crutchfield with the Metra Axxess Boxes. I could not get the receiver to operate with the steering wheel control switches or get the rearview camera to show up on the receiver as well. After talking to Axxess about the issue in regards to the SWC box they stated that since the car was made in Canada from Honda, that the wiring is a bit different. The solution to this issue is you will need to cut 3 wires going into the 12 pin connector to SWC box as follows ( GREY W/Red Stripe), (BLUE W/Pink Stripe), (SOLID PINK). After cutting the wires tape off the ends or shrink wrap them separately. Turn back on the ignition and Reset the SWC Box for 3 seconds and let it program and should work. Note* the Bluetooth buttons will not opperate unless in a call.
As far as the camera this part was a bit of a test method and reading the forums. From the Axxess Nav box, you will need to cut the Dark Green W/ Purple Stripe from the 12 pin connector to the Nav box. Following that I stripped the wires and ran it through the drivers side kick plate to the Reverse light wire and tapped the Lime Green wire in the corner. This should fix your issue if your vehicle is not registering any video feed or even your car being placed into reverse. This method also only operates the camera when in reverse as it should.
Figured i would just post these seeing that I have not seen any solutions to the issues i had and might help someone trying to install an aftermarket receiver and same them about ten hours of a headache.
As far as the camera this part was a bit of a test method and reading the forums. From the Axxess Nav box, you will need to cut the Dark Green W/ Purple Stripe from the 12 pin connector to the Nav box. Following that I stripped the wires and ran it through the drivers side kick plate to the Reverse light wire and tapped the Lime Green wire in the corner. This should fix your issue if your vehicle is not registering any video feed or even your car being placed into reverse. This method also only operates the camera when in reverse as it should.
Figured i would just post these seeing that I have not seen any solutions to the issues i had and might help someone trying to install an aftermarket receiver and same them about ten hours of a headache.
Sponsored