Flex Fuel Converter wiring

I am wiring a new Ktuner Flex Fuel converter to a new Ethanol Sensor to ect2. I believe the wires go....

- power and Ground are obvious/ red and black
- white wire from Ethanol Sensor to white wire on converter
- yellow wire from Converter to ect2

Sounds simple but something caused my old Converter to stop working.

We sent you a new wiring pigtail because you said after hooking the unit up one of the wires was "shot". You then said none of the voltages are correct.

You're supposed to send it in so we can check it out. Until then we're assuming it was wired incorrectly leading to the above.

KTuner said:

We sent you a new wiring pigtail because you said after hooking the unit up one of the wires was "shot". You then said none of the voltages are correct.

You're supposed to send it in so we can check it out. Until then we're assuming it was wired incorrectly leading to the above.

Click to expand...

I just bought a new one, please just confirm my wiring listed above is correct please.

Why can’t anybody answer my question?? I was told I mis - wired it, so what’s right??

KTuner said:

http://ktuner.com/KTunerHelp/flex_fuel_converter.htm

Click to expand...

Thanks