Turbo blanket

Question,
Do i need to uninstall dp to fit in turbo blanket??
Is USR or P2P same quality?

123sillyboy123 said:

Question,
Do i need to uninstall dp to fit in turbo blanket??
Is USR or P2P same quality?

Click to expand...

No you don’t need to remove the downpipe, just the heat shield and from my understanding USR purchases from PTP and rebadges it.

I put mine on when I was swapping my downpipe out, so I had the inlet pipe off along with the downpipe. Even with the dp off the blanket was a bit of a pain to get on and orient correctly. I wouldn't have wanted to try it with the downpipe still attatched.

123sillyboy123 said:

Question,
Do i need to uninstall dp to fit in turbo blanket??
Is USR or P2P same quality?

Click to expand...

IMO, yes you do if you're running a stock dp. You're very welcome to try but i bet you're going to have a helluva time and you'll need to get quite creative to come close. In the end, you'll find it easier with the dp out of the way. But, if you already have aftermarket dp, then you don't need to remove it.
But, its easier if you don't break the studs. Either way, it's going to be quite a chore the first time around. If you're going to tinker around in the engine and add more parts, i'd wait to do everything at once.

good luck!

IHadToRun said:

No you don’t need to remove the downpipe, just the heat shield and from my understanding USR purchases from PTP and rebadges it.

Click to expand...

How did you go about removing the heat shield?

Lust said:

How did you go about removing the heat shield?

Click to expand...

I would love to tell you but I haven’t installed one on my own yet just read a lot about it from my understanding I believe their are 3-4 bolts though