REQUEST: Clutch install on 1.5t

Just adjusted the clutch bolt all the way out and master-cylinder rod to match. SO much better now; just steady pressure all the way through, not a dang leg workout like before. It takes up somewhere around halfway now. Very slight slack in the MCM rod linkage - can move the bracket at the end of the rod side to side just a hair - Will tighten sometime soon. Very excited for this thing now!

Finally at about 500 miles. Chatter is almost down to zero. Clutch holds strongly; still on stock tune for a bit longer, then will put the Stage 1 back on and let it rip. Aiming for Flex Fuel tune this spring or summer.

Just wanted to bump this. I am interested in DIY'ing this, but would want to have some instructions to go by if possible. Are there any write ups available for this?

davemarco said:

Just wanted to bump this. I am interested in DIY'ing this, but would want to have some instructions to go by if possible. Are there any write ups available for this?

Click to expand...

Lol that would be a long ass write up

They had those write ups on all the other Gen civics... Hoping one comes out for this before I need another clutch. If not, it shouldn't be that much different than other write ups.

Maybe a few different tricks and what not

Itd be nice to see a DIY step by step with details.
I know its alot of work. Removing harnesses, lots of bolts, dropping the subframe, removing the axle, steering rack, etc

FYI, I just read you dont need to remove subframe to change the clutch