06S2k07Si
Senior Member
- First Name
- Brian
- Joined
- Feb 13, 2018
- Threads
- 8
- Messages
- 275
- Reaction score
- 191
- Location
- Wisconsin
- Vehicle(s)
- 06 S2000 22 RDX 13 CB1000R 22 Veloster N 18 Type R
That's excellent! OCD?...yeah. ..I get accused of that all of the time too...but really, I just think it's about doing stuff right and with a good amount of effort! In my opinion?...don't ever change that! I don't think we have enough of that in the world today! ...nice attention to detail!the way it sits works out really well. the plexi is sunken and is 1/8" lower than top side of folding floor lid with full cutout. the top of the stainless steel finishing caps of the standoffs are actually 1/8" higher than the plexi so are flushed with top side of folding floor lid.
the trunk liner has partial centered cutout for a simple reason - i'm ocd and can't stand an off-center cutout. therefore the bottom of the trunk liner covering the plexi sits on top of the finishing caps. the removable/reusable trunk liner cutout as a "cap" sits on top of the 4 finishing caps in that partial yet centered cutout.
everything is flushed with each other per layer. therefore, under the tray liner and only the area right above the plexi is covered with black velvet sticky back material which is soft and "absorbs or cushions" any particles or sand that could scratch the plex when covered.
Sponsored