I love your style there! Looking good!Added some carpet protection for the R . . .
I luv em. (Mannici Luxury Mats) Kind of an alternative to Weathertech. Easy to keep clean and cushy too. I need some Type R slippers. Lol!!
Be very careful as you really only have 1 chance. There are 2 cutouts. I just lined it up at the edges of the rear H. Use some masking tape to help line it up. The paper holding the decal lined up with the edge of the hatch. I was 1mm off on the right vs. the left, though it's centered. Lol don't think anyone really notices but myself.
Grab a flashlight and shine it on the back of the glass under the brake light you will see two triangles that you can line the sticker up with. They are almost invisible unless you look at the correct angle with the proper amount of light. I received this information courtesy of RedFK8
Nice, how much of you don't mind me asking? Places around here want an arm and leg.
Had a full paint correction, opti-coat pro coat on the paint , glass , wheels , calipers.
Much better guide.Grab a flashlight and shine it on the back of the glass under the brake light you will see two triangles that you can line the sticker up with. They are almost invisible unless you look at the correct angle with the proper amount of light. I received this information courtesy of RedFK8
No issues, car feels good.
Looks good, but just a heads up that I did this on my’06 Si & the halogens burned the Laminx film. Not sure if the LED’s get hot enough, but just something to watch for. I must say that the JDM fogs are pretty sweet. Expensive, but very high quality. They look good even when they are off.Cheap mod that works. Save your money and time by not replacing with some damn expensive JDM yellow fog light units requiring bumper removal.
Lamin-X yellow fog lights protective film, best there is. Just need enough to cut 2 circles at 2.75” diameter (or 3” diameter and trim off if you can’t tuck in the edges all the way. Easy...
I always install any film with a spray steamer, best technique to soften and mold the film. Squeegee out the moisture and bubbles. Done!
Here, https://www.lamin-x.com/Two-8-x-8-Yellow-Universal-Film-Covers-p/2-88y.htm
Nope, no worry since CTR fogs are LEDs not halogens. I never film halogen lights for that exact reason, heat. That’s the whole point of LEDs since they run cooler.
thanks guys. i bought three but really just want to use one save the other two. great advise. i will do this next week after my wash.
nice but in all honestly it was very simple to remove the fog light covers. you don't even have to remove the bumperCheap mod that works. Save your money and time by not replacing with some damn expensive JDM yellow fog light units requiring bumper removal.
Lamin-X yellow fog lights protective film, best there is. Just need enough to cut 2 circles at 2.75” diameter (or 3” diameter and trim off if you can’t tuck in the edges all the way. Easy...
I always install any film with a spray steamer, best technique to soften and mold the film. Squeegee out the moisture and bubbles. Done!
Here, https://www.lamin-x.com/Two-8-x-8-Yellow-Universal-Film-Covers-p/2-88y.htm
