where did you purchase the garnishesNew 2020 garnishes , front and rear . I was able to re use my license plate relocator without having to cut into the vent .
Loving them
It’s just a tinted film. It fits perfectly . I’ve had it for almost a year and it’s still intact !What kind of blacked out headlights you got going on here? Tint film or aftermarket unit?
College hills . I got lucky as it took so little time !where did you purchase the garnishes
I just used a jack and 2 pry bars to get that RMM in, it was a serious fight because I REFUSED to loosen anything else!I had to do the same thing and completely remove the PRL front pipe. One thing I did do though too is take a grinder to the end of that bolt so that if I ever have to take it out again I don't need as much clearance and could get away without removing the front pipe.
report back after a couple of driving sessions and link us then?Installed this black “sound deadening” weather stripping I found off AliExpress - $20 total. Hopefully it’ll cut down on wind noise, like it says. No glue, the rubber has a channel that the rear passenger door edge fits into.
Seems like it would be easier to just downshiftdid some sound deadening. Trying to get rid of this slight buzzzing at 2.5k’ish rpm in the rear of the car. It helped but just a little.
any other good spots?
Report back on how it works out!Installed this black “sound deadening” weather stripping I found off AliExpress - $20 total. Hopefully it’ll cut down on wind noise, like it says. No glue, the rubber has a channel that the rear passenger door edge fits into.