So I decided to tint my fogs today. I was debating between tinting them or led bulbs to match the rest of the lighting. I ended up going with the tint and I'm glad I did. Cost me a whopping $10 for a sheet of yellow tint too! What do you guys think?
That's cool. But I wanted to match the LED Head lights and Day time driving LED.
I got phillips extreme LED fog lights.
Amazon...it was like $11 for a 1ft×5ft sheet.
Ooohh I like. How hard was it to get to the back of the fog lights? I heard it's a process.
Not hard at all, just one 10 mm bolt and four clips . And one in the fender well. The hardest part was to figure out how the clips work . Need to pull out the Center pin just a little up. Then the whole clip just drops off. Then pull down the plastic/rubber flap. The bulbs are likeright there . If you take your time, it takes like 15 min.
Mind sharing where you bought it? Looks great!
Looks like amazon has them for under $100 for the set... I think I will get these when I grow tired of the yellow tint.
Yes these are the LED bulbs I used for the Fog light. Very bright. And a perfect match with the other stock LED's.Looks like amazon has them for under $100 for the set... I think I will get these when I grow tired of the yellow tint.
Thanks guys, ordered!
Curious, did you have any extra/hanging wires with this install? Seen other lights that don't appear to have that extra section of wire, though they say you may need a load resistor. Would rather a nice snug option without the extra slack, but I also don't trust the other lights nearly as much as I would Philips.
There was a small wire hanging down behind the bumper. Tied the driverside next to the windshield fluid tank.
So I decided to tint my fogs today. I was debating between tinting them or led bulbs to match the rest of the lighting. I ended up going with the tint and I'm glad I did. Cost me a whopping $10 for a sheet of yellow tint too! What do you guys think?
