Thoughts on Spoon N1 vs Sequence exhaust

[moonrobin]

My exhaust came with all the parts needed, including the hose, T connector, and clamps. It didn’t come with gasket though. Joe said if you’re connecting to the stock front pipe, you don’t need a gasket.

You may need some insulation foaming (as suggested by @boosted180sx ) if you run the hose from the passenger side to reduce possible rattle with the bottom heat shield.

I should have unboxed the package before making my previous post, can confirm that the exhaust comes with the hose, clamps, and t-joint. Using the hose and a bike pump, I verified the valve opens up all the way smoothly and at the expected PSI threshold (~ 5 PSI).

Regarding that gasket, I'm actually swapping my front pipe to a PRL one as a part of this install, will I need to source a gasket independently for that?

Sponsored

 

[Sam3]

Regarding that gasket, I'm actually swapping my front pipe to a PRL one as a part of this install, will I need to source a gasket independently for that?

You should be able to use the PRL gasket that comes with the front pipe.