skottharrison
Senior Member
- First Name
- Skott
- Joined
- Oct 10, 2020
- Threads
- 15
- Messages
- 215
- Reaction score
- 142
- Location
- South Florida
- Vehicle(s)
- 2020 Civic SI Sedan, 2021 Subaru Crosstrek
- Thread starter
- #16
May just have to... thanks!
Sponsored
it would not require bleeding, just refilling the reservoir. This is the highest point in the system. I was going to use a turkey baster and suck the reservoir dry. Then disconnect the two tubes. There are maybe three small bolts to remove and then just lift it out. It’s not bad at all. Just have towels and rags to manage any spills. I’m gonna wait till Black Friday and pick one of these replacements upHas anyone removed the tank and painted it with success? I'm getting to that point where my engine bay is coming along but this tank is insanely ugly. Any instructions/tips/tricks on the removal and replacement? I know to use shop rags as it'll spill and maybe top it off some but I'll have to find the technical document on how it's installed.
Also do you need to bleed it afterwards? I'm not very knowledgeable in this area.
Pic of my engine bay for reference:
Thanks!
What all is required to make it work for Si?I replaced mine with the FK8 Radium Expansion Tank… definitely cleans up the engine bay… ??
What all is required to make it work for Si?
Hope this view helps. Slight angle as it sits with the chassis tower.Quick question… does the radium tank sit parallel with the valve cover? Or is it a slight angle?