Red H Emblems, who has them?

[Aegean303]

Call College Hills Honda and order online.. They will take care of you. That is where I bought mine. About $300 For the Hatch grill and both H emblems.

I’ll call them later this week, just seems I’d pay more for shipping lol but I found a dealership in my area that sold and installed the hatch back grill for 520$... talk about shocking haha

Sponsored

 

[HondaPro]

College Hills Honda is normally cheaper than most dealers. Call them first then check around. Install on the grill isn't that hard. It's just a matter of setting aside a Saturday to do it. I used plastic ramps from walmart to elevate the front before I started. Take it slow and take your time. The only trick was where the small clips attach the grill to the bumper

I’ll call them later this week, just seems I’d pay more for shipping lol but I found a dealership in my area that sold and installed the hatch back grill for 520$... talk about shocking haha

 

[tdoto]

What is everyone’s opinion on the badge on a ralleye red civic?

Red on red

 

[XpoH]

What is everyone’s opinion on the badge on a ralleye red civic?

Red on red

Front one looks awesome, rear one, well I'm not sure about that. IMO

 

[tdoto]

Front one looks awesome, rear one, well I'm not sure about that. IMO

Hit the nail with that! Wondering how it would look with plastidip in back and JDM on the front

 

[DoingOK]

Installed front and rear emblems. Not bad.

 

[MyVeryFirstSi]

Installed front and rear emblems. Not bad.

Did you get these from the dealer or did you order them from somewhere like: icbmotorsport? The red emblems look so good on this color, I have the same color

 

[DoingOK]

Did you get these from the dealer or did you order them from somewhere like: icbmotorsport? The red emblems look so good on this color, I have the same color

I ordered them through a dealership to ensure I got the real deal.

 

[MyVeryFirstSi]

I ordered them through a dealership to ensure I got the real deal.

Awesome I was planning on going this route as well, did you have to tell them you needed them specifically for your car? (Not sure if yours is an Si coupe or Si sedan) or are these the ones that are from the type R?

 

[556ALPHA]

Awesome I was planning on going this route as well, did you have to tell them you needed them specifically for your car? (Not sure if yours is an Si coupe or Si sedan) or are these the ones that are from the type R?

Just order two Type R oem front emblems if you have a Coupe.

 

[556ALPHA]

Awesome I was planning on going this route as well, did you have to tell them you needed them specifically for your car? (Not sure if yours is an Si coupe or Si sedan) or are these the ones that are from the type R?

Yours seems to be a Sedan so follow the thread advice


Here is the best way to determine what you need based on a collection of posts in this thread. It appears just ordering OEM Type R front and rear woll work fine. I have no knowledge but if the pins on the rear do not line up you may have to take them off and just use the tape.

If you buy a Coupe order 2 of the Type R front H emblems. On a Coupe the front and back is the same.

↑
RED JDM part# & sizes
---------------------------------------------------------
75701-SLJ-003, W:131mm x H107mm
75700-S5T-E11,W:123mm x H100mm
75700-SNW-003,W:113mm x H:92mm
75700-SYY-003, W:108mm x H90mm
75700-SMT-E00, W:98.40mm x H:79.65mm
75701-SNW-003ZC,W:95.20mm x H:77.30mm
75700-S5T-E01, W:92mm x H:75mm
75701-S6M-Z01, W:86.13mm x H:69.73mm
75701-S1A-E11ZB, W:79.4mm x H:65mm
75701-TF0-003, W:92mm × H:75mm

10th gen civic oem emblem sizes
---------------------------------------
sedan:
front - 117mm x 96mm
rear - 108mm x 88mm

coupe:
front&rear - 117mm x 96mm

hatchback:
front - 117mm x 96mm
rear - 103mm x 85mm



most likely if youre ordering from icb they will send you 1x S5T-E11 and 1x SNW-003 for sedan/hatch...which is oversized

if you have seen @jonnys_honda build thread, those are the emblems he got and states they are too big but made it work by using more tape

in regards to whether or not you have to break the pins, it really doesnt matter...remember that these emblems are not made specifically for 10th gen civics so the pins may not line up and their only purpose is for alignment...the tape is what holds it in place

what are your options?
a) order emblems from icb like normal and make it work using more tape
b) go a size under (call/email icb stating which specific emblems you want)

*for hatch owners, either:
-wait til type r comes out so proper sized badges are released or
-make it work with what icb sends you or
-undersize and get snw-003 and smt-e00
↑
Let's sing.. Ohhhh Christmas tree....... Oh Christmas tree...... Bla Bla Bla Blaaa Bla Bla Blaaaaaaaaaaaaa





sedan:
front - 117mm x 96mm
rear - 108mm x 88mm

coupe:
front&rear - 117mm x 96mm

hatchback:
front - 117mm x 96mm
rear - 103mm x 85mm

Bodysizes (source):
2-door coupe - FC3/FC4 (emblems)
4-door sedan - FC1/FC2 (emblems)
hatchback - FK7 (no emblems yet...)
↑
So what size are people using for rear emblem for the sedans?
↑
This is oem Real Rear TypeR badge bought from Honda Dealer USA and how it fits a sedan.

 

[Alkimist]

La la la la... just and patiently waiting for the right badge for my 2018 hatch sport touring.

 

[tdoto]

La la la la... just and patiently waiting for the right badge for my 2018 hatch sport touring.

ETA on mine is nov 7

 

[Alkimist]

ETA on mine is nov 7

Must be excited eh? And I know that you’re having a hard time sleeping right now. Lol

 

[kkim]

Can anyone recommend a red steering wheel emblem and the brand that you bought?

Sponsored