newskate9
Senior Member
- First Name
- Stephen
- Joined
- Oct 23, 2018
- Threads
- 33
- Messages
- 259
- Reaction score
- 231
- Location
- PA
- Vehicle(s)
- 19 Type-R, 16 Honda Pilot Elite
- Thread starter
- #1
OK, so first, I'm not a master mechanic but I know what a screw driver is, and I (think) can follow directions. That said.......
I'm in the last stages of install, and this thing does NOT fit. The first picture here is from the instructions.
Notice the "large" vertical hose is lower than the "small" vertical hose. Notice how the hoses coming off the top are able to tuck under the engine cover. Now look at mine:
Notice the LARGE hose is higher than the SMALL HOSE. The whole unit is still loose so it can move any way it wants, but I think it is in the correct orientation. The small hose into the inlet is a HARD pipe, so it can only move so far. I'll accept any negative feedback if I screwed something up - but I don't I did.
PLEASE, any thoughts?
I'm in the last stages of install, and this thing does NOT fit. The first picture here is from the instructions.
Notice the "large" vertical hose is lower than the "small" vertical hose. Notice how the hoses coming off the top are able to tuck under the engine cover. Now look at mine:
Notice the LARGE hose is higher than the SMALL HOSE. The whole unit is still loose so it can move any way it wants, but I think it is in the correct orientation. The small hose into the inlet is a HARD pipe, so it can only move so far. I'll accept any negative feedback if I screwed something up - but I don't I did.
PLEASE, any thoughts?