For all of us that are just watching to see first results, what's the problem specifically?... Assume it's something with the wastegate after heat cycle???
It's the exhaust side of the turbo. With he waste gate actuator.
I dont know how to swap that stuff out =( Are you guys just leaving them or what since he said that if it was going to happen it probably would have happened?
Rv6 said so.eone had an issue with the waste gate actuator sticking and it might be because there isn't enough clearance for the actuator shaft. Once it heats up it is sticking.
Since I didn't install mine I'm gonna wait for the new housing
Yeah this is gonna be a first for me but shouldn’t be too hard
I've rebuild centrifugal super hargers which is similar enough
Thats what he said, I don't think we are going to get the housings really soon anyways. Hopefully your doesn't have this issue, but it wouldn't be a bad idea to change out when the housing comes in.
yeah I dont feel comfortable taking a turbo apart, nor do I have the time or money to take all that apart over again unfortunately.
Are you close to Cali I can help you
Zach your emails are bouncing. It says your inbox is full.
One person had their wastegate stick right after starting. We just want to make sure it doesn't happen again. My car and all the test cars have been fine.
The turbine housing is the part that bolts to your engine. You can swap it with just removing one nut and loosening a clamp. It is not hard at all and only takes about a minute. However if your car is running fine I wouldn't worry about it.
Just one part.
There is a alignment pin so super simple.
