Lowering springs uneven rear

[ctrsg]

hi guys, i just installed rsr lowering springs a few days ago and the rear driver side is lower than the rear passenger side By about 10mm.
i just did alignment too and its the same.
would the springs settle down after a while to be even in the rear?
is this normal?

thanks guys

Sponsored

 

[yansag1982]

are you sure the car was on FLAT ground like a concrete slab when you checked it?

 

[ctrsg]

are you sure the car was on FLAT ground like a concrete slab when you checked it?

Yes i m sure its flat

 

[JohnInATL]

I can't comment on RSR springs, but when I installed my springs, the rears weren't marked L or R, so I just made sure the printed logos/numbers on the springs faced the same direction (up) when I installed them and didn't have any issues.

When I checked the ride height before/after I had the car on an alignment rack.

Also double check that your rubber isolators are aligned with the coils properly. I believe the bottom ones in the back have small tabs that should be pushed through the lower control arms.

 

[Hayabusa160]

was the camber even on both sides the side with more camber will be lower

Sponsored