dellyjoughnut
Senior Member
- Joined
- May 16, 2019
- Threads
- 12
- Messages
- 351
- Reaction score
- 176
- Location
- Los Angeles, CA
- Vehicle(s)
- Toyota 4Runner, '19 Civic Sport Hatchback
- Thread starter
- #1
My first time doing rear sway bor change. I removed my FK7 endlinks to install the Accord ones and found I could rotate 360 them while on the sway bar. The Accord endlinks can also rotate 360. Since Whiteline doesn't provide an installation guide, I used the factory service manual. It does state to tighten while under load. What confuses me is if the endlinks are tightened under load yet they can pivot 360 not under load, doesn't this defeat the purpose of tightening under load because of that free play?
Sponsored