seed3540 Senior Member Joined May 20, 2020 Threads 8 Messages 70 Reaction score 26 Location Georgia Vehicle(s) CTR Jun 16, 2020 Thread starter #1 Hello Everyone, I am planing on wrapping my inlet pipe with DEI Gold Tape. Does anyone know what the torque specifications are for the bolts to the turbo? Also can the gasket be reused or should I get another? Thank you! Sponsored
Hello Everyone, I am planing on wrapping my inlet pipe with DEI Gold Tape. Does anyone know what the torque specifications are for the bolts to the turbo? Also can the gasket be reused or should I get another? Thank you! Sponsored
Patrick Bateman Senior Member Joined Oct 28, 2018 Threads 8 Messages 334 Reaction score 245 Location Florida Vehicle(s) ‘18 FK8, ‘19 XC60 R-Design, ‘17 ZL1, ‘02 SS Jun 16, 2020 #2 I reused the gasket. I’m usually pretty meticulous about torque specs, but I just wrenched them down. I’d say ~20ft#.. with that said torque specs are dictated by the fastener..here’s a generic chart. They’re M8..
I reused the gasket. I’m usually pretty meticulous about torque specs, but I just wrenched them down. I’d say ~20ft#.. with that said torque specs are dictated by the fastener..here’s a generic chart. They’re M8..
OP OP seed3540 Senior Member Joined May 20, 2020 Threads 8 Messages 70 Reaction score 26 Location Georgia Vehicle(s) CTR Jun 17, 2020 Thread starter #3 Thanks so much for this. I wanted to make sure that I didn't end up with a boost leak. Sponsored