IAT and ECT Torque Pids Confirmed

[das borgen]

Check under "units" in the settings menu

but that's what I was explaining. Under my settings, I have F as my defaut unit set, but the gauge still shows up as being Celsius. How did you fix that?

Sponsored

 

[das borgen]

Despite the PID module being in C, once the car is running, Torque automatically overrides the units to F on the module because the default unit is F.

All is well

 

[Dimitron84]

Despite the PID module being in C, once the car is running, Torque automatically overrides the units to F on the module because the default unit is F.

All is well

Yup what he said, it will auto convert it

 

[kalvin126]

What is MAFA in your picture?

 

[Dimitron84]

What is MAFA in your picture?

Not sure, I borrowed this scanner from a friend

 

[kalvin126]

ok, Any ideas on how to get the MAF reading? the regular MAF air flow PID is not reading for me. ECU says its unsupported as well.

 

[Alkimist]

I have a wifi obd2 always plug on my car but everytime i turn off the car and turn it back on i have to disconnect the obd2 adapter and reconnect it back again for the car to detect the wifi obd2. I also have hondahack pro so everytime i start the car it automatically goes to torque pro realtime information. Do you have any solution to this? so i dont have to unplug and plug the obd2 adapter, and thanks in advance

 

[saiko21]

OP, IAT11 is pre intercooler and IAT12 is post intercooler right. Can you please give me PID code for IAT12 for torque application ?

 

[tripodog]

Is there a pid for the vtec? (I have k20)

Sponsored