How do I switch maps on TSP stage 1?

[KTuner]

Honda directly.

Sponsored

 

[CDub_1988]

A screenshot I took on my phone a while back, hopefully this helps!

 

[J_V]

Honda directly.

thanks and I have to flash back to stock before heading there correct?

 

[KTuner]

Always a good idea!

 

[IamPau]

I have a 2016 10th gen Civic touring. As instructed, I held on the cancel button (5 sec) with the cruise control off.

Tried with engine on, ignition on (engine off), but both didn't seem to work.
I don't see the rev meter moving to indicate map switching.

I do feel the difference in performance after flashing TSP stage 1 though.

What am I doing wrong?

hey budd, was this issue ever resolved? I reckon Im in the same boat as you were..

 

[TrinityTek]

I know this is an old thread but I found it while stuck at the same point and searching for a solution. In my case I had been trying to switch the mapping with the engine not running and the key in the accessory position. Once I tried carefully following the instructions with the engine running in neutral I was able to successfully select my mapping. Hope it helps someone.

 

[BigBeard_FK7]

Not sure if you ever resolved this but try making sure your acc/load is turned off before doing it. It won’t let you switch if that’s on.

Sponsored