Help..clutch problems?

[bgutierrezx]

I installed a fx350 & my car won’t go into gear when it’s running. I’m also not sure how to adjust the clutch pedal.. any suggestions ?

Sponsored

 

[360glitch]

You need to adjust the pedal. On the backside of the pedal arm is a rod that connects to the master cylinder. You need to loosen the lock nut on the backside of the yoke (piece that connects rod to pedal arm) and then thread the rod away so that fewer threads are showing through. Small adjustments can go a long way, you will likely have to play with it a bit.

Also expect to have to adjust it later as the clutch breaks in. Have fun!

 

[bgutierrezx]

You need to adjust the pedal. On the backside of the pedal arm is a rod that connects to the master cylinder. You need to loosen the lock nut on the backside of the yoke (piece that connects rod to pedal arm) and then thread the rod away so that fewer threads are showing through. Small adjustments can go a long way, you will likely have to play with it a bit.

Also expect to have to adjust it later as the clutch breaks in. Have fun!

Is this what you’re talking about ? I need to take off the safety pin & adjust it like that?

 

[bgutierrezx]

I’m guessing I have to press on the clutch pedal while I adjust it, since that rode Can’t come
Out anymore.

 

[AREA]

No just loosen the nut and turn the rod by hand. The nut is near the cotter pin side/pedal side. You want less rod play.

Sponsored