FS: PLM 3" Front Pipe

[LilToTo17]

This PLM 3" front pipe will fit a stock dp or their own PLM dp. Sad to say it did not fit with my RV6 catless dp as it was a about an inch gap. Selling it for 200 shipped or obo View attachment 79680 View attachment 79681 View attachment 79683

Sponsored

 

[Shankmeyster]

Doesn't bode well for PLM product development if their products don't fit in the stock positions. Your stock FP fits in there with no gap right?

 

[LilToTo17]

Doesn't bode well for PLM product development if their products don't fit in the stock positions. Your stock FP fits in there with no gap right?

Correct but remember I have an RV6 Modular dp which is a little different than stock or other products.

 

[MacKharoni]

Suck i got a rv6 pipe too. I haven't install prl fp yet but i heard prl fp fits

 

[LilToTo17]

Suck i got a rv6 pipe too. I haven't install prl fp yet but i heard prl fp fits

That's good to know. They told me it would fit lol with some adjustments. I am talking to them and the guy who has the video of the PLM combo on youtube.

 

[dc2turbo]

RV6 downpipe is the same length as oem
Sounds like PLM fucked up. did you lay the stock and plm on top of each other to see if its a 100% match?

I would demand a refund

 

[LilToTo17]

RV6 downpipe is the same length as oem
Sounds like PLM fucked up. did you lay the stock and plm on top of each other to see if its a 100% match?

I would demand a refund

It looked a little shorter then stock fp but hard to tell. It is possible I might have gotten a bad pipr but idk. If you buy their product go with combo obviously and never mix and match unless it's stock lol.

 

[LilToTo17]

They told me that they wouldn't charge the 20% restocking fee but would take away their shipping cost of $25 and have me pay for shipping as well which by fedex is $14 which doesn't add up

 

[Shankmeyster]

Everyone's aftermarket parts should fit in the stock positions, otherwise that would be a design flaw or they would have to say in writing "DOES NOT FIT STOCK PIPING".

 

[LilToTo17]

Everyone's aftermarket parts should fit in the stock positions, otherwise that would be a design flaw or they would have to say in writing "DOES NOT FIT STOCK PIPING".

Well it didn't fit haha at least for me with my RV6 downpipe.

Sponsored