Emissions Problem after Fog Light Install

[ramnj]

Finished connecting my fog lights. When I started the car I’m getting and emissions error. Looked through the settings for a way to reset it but could not find one.

Anybody had this problem? TIA.

Sponsored

 

[dc2turbo]

Do you have any mods?
You can reset it with a scanner or just disconnect the battery for a few seconds

 

[ramnj]

I disconnected the battery for about 30 seconds but didn't work. Don't have a scanner and haven't done any mods other than install the fog lights.

 

[Civic-it]

Hmm....maybe you bump a wire or something while installing?

 

[ramnj]

Hmm....maybe you bump a wire or something while installing?

Your right...but a little worse. While trying to feed the fog light wire through a grommet I nicked a wire the has something to do with the emissions. I taped the wire and everything is back to normal...thanks.

 

[Moab23]

Your right...but a little worse. While trying to feed the fog light wire through a grommet I nicked a wire the has something to do with the emissions. I taped the wire and everything is back to normal...thanks.

What wire is it that you damage? Is it the one that connects directly to catalytic? That’s really far from fog lights unless you installed hids with harness...

 

[ramnj]

Underneath the dash by the pedals there's a grommet that I was trying to get the wire through and nicked the wire inside the harness.

 

[Moab23]

Underneath the dash by the pedals there's a grommet that I was trying to get the wire through and nicked the wire inside the harness.

Ooooooh ok any pics by chance?

 

[ramnj]

Ooooooh ok any pics by chance?

No. I had to bend like a pretzel to get under there and the pics I took don’t show crap.

 

[Moab23]

No. I had to bend like a pretzel to get under there and the pics I took don’t show crap.

Gotcha thanks!

Sponsored