Eibach Pro Kit

[Beks]

I’ve never lowered a car before. After a bit of research, I’ve determined that the eibach pro kit will be the height I’m going for. I got the camber arms so alignment and tire wear don’t become an issue.
Really looking for guidance on what to do with my wheels/tires to get that stocky, fitted look. Any help is welcome

Sponsored

 

[jayy_swish]

I’ve never lowered a car before. After a bit of research, I’ve determined that the eibach pro kit will be the height I’m going for. I got the camber arms so alignment and tire wear don’t become an issue.
Really looking for guidance on what to do with my wheels/tires to get that stocky, fitted look. Any help is welcome

Like a flush Fitment or poke?

 

[Beks]

Like a flush Fitment or poke?

Flush

 

[jayy_swish]

Flush

If you have stock tires you will need a +20 or +25 wheel spacer depending on what trim level you have
+35 for flush Fitment
+30 for dead center with the fender (might need to get them rolled or add negative chamber depending on wheels)

Photo is 18x8.5 +35 on Eiback Sportline Springs

 

[Beks]

If you have stock tires you will need a +20 or +25 wheel spacer depending on what trim level you have
+35 for flush Fitment
+30 for dead center with the fender (might need to get them rolled or add negative chamber depending on wheels)

Photo is 18x8.5 +35 on Eiback Sportline Springs

Thank you. I have a 2020 Si Coupe on stock wheels/tires.. just want to get the plan right before I do anything

 

[jayy_swish]

Thank you. I have a 2020 Si Coupe on stock wheels/tires.. just want to get the plan right before I do anything

I believe those are 18x8 +50 so I would go with +20 spacers. You will need hub centric spacers with a center bore of 64.1 mm and a bolt pattern of 5x114.3

 

[Beks]

I believe those are 18x8 +50 so I would go with +20 spacers. You will need hub centric spacers with a center bore of 64.1 mm and a bolt pattern of 5x114.3

You are beyond helpful, thank you

 

[MutatedMango]

I believe those are 18x8 +50 so I would go with +20 spacers. You will need hub centric spacers with a center bore of 64.1 mm and a bolt pattern of 5x114.3

Can you get flush fitment without spacers?

 

[jayy_swish]

Can you get flush fitment without spacers?

It’s either run spacers or buy some new wheels, no other option. Spacers are safe if installed correctly and using a reputable brand, especially with something like a +20mm spacer. Check out my thread about aftermarket wheels and go ahead and direct your questions there if you like also.

https://www.civicx.com/forum/threads/fitment-industry-10-gen-wheel-guide.47916/

Sponsored