DIY: Retrofit Front Seat Belt Holder Civic Coupe

[ajsti24]

I got tired of reaching for the front seatbelt, retrofit a pair of BMW Seat Belt Holder:
Part Number: 52-30-2-208-036 Cost $49 shipped to my house from ECS Tuning

Driver's Side:

Passenger Side:

Install Rubber Inserts:

Adjustable width to fit the headrest post:

Thanks For Looking!

 

[Alphaskoom]

These are great, but every time someone who's not familiar with the car gets in, they end up "breaking off" the little clip part.. and they also fall off when the seats go forward... I'm tempted to just glue them together so they don't fall apart so easily. anyone else have a similar experience with these?

 

[Surgeenyc]

These are great, but every time someone who's not familiar with the car gets in, they end up "breaking off" the little clip part.. and they also fall off when the seats go forward... I'm tempted to just glue them together so they don't fall apart so easily. anyone else have a similar experience with these?

I actually bought these because of this post from OP but soon found myself in that situation. I burned the plastic together so it stops moving but wasn't that great. IMO not worth...

 

[Alphaskoom]

I may go about finding a way to epoxy it together or something soon, luckily opening up the rear access is not something i do regularly. but yea the forces the belt go through when the seat slides forward is quite an odd angle to brace for. I do enjoy the fact it holds the passenger seat belt away from the door panel / rear quarter panel and prevents it from slapping against it in the wind when i drive with the windows down or turn a corner. ill try to look into a better modification solution

Sponsored