Did I tune incorrectly?

[Mckeeversheater]

I have a 2016 honda ext cvt with Honda sensing
My car already feels different after the tune but I was told on another thread that I should be able to flip through my maps by using the cancel button but I don’t have anything pop up on my tach when I do so

Sponsored

 

[hobby-man]

What ECU software are you running? I.e. does it support the map switching?

Have you disabled Cruise Main before trying?

 

[gtman]

OP, nothing "pops up" on your tach. Let me try to explain in detail for you.

After pressing and holding down the cancel button for 2-3 seconds, use resume and set to change maps.

Here's where you need to look at your tach carefully. The resume and set buttons act as up or down for map selection. The tach will show 1,000 rpm for map 1, 2,000 rpm for map 2 and 3,000 rpm for map 3.

Once you decide on a map, press the cancel button again for 2-3 seconds and you will see the tach move back to actual engine rpm. At that point the map you chose is loaded.

 

[NorrinRadd]

For clarification... What tune did you flash, and how did you flash it? I'm assuming you flashed the TSP stage 1 tune with KTuner?

If so, what gtman posted is spot on.

 

[Mckeeversheater]

OP, nothing "pops up" on your tach. Let me try to explain in detail for you.

After pressing and holding down the cancel button for 2-3 seconds, use resume and set to change maps.

Here's where you need to look at your tach carefully. The resume and set buttons act as up or down for map selection. The tach will show 1,000 rpm for map 1, 2,000 rpm for map 2 and 3,000 rpm for map 3.

Once you decide on a map, press the cancel button again for 2-3 seconds and you will see the tach move back to actual engine rpm. At that point the map you chose is loaded.

Thanks so much man that helped a lot!

Sponsored