Broke white clip/pin during bulb replacement

[Delix]

I broke a white pin/clip while trying to replace one of the bulb in my right tail light. Is this part replaceable or do I need a new tail light?
I can't figure out which part this is.
https://www.collegehillshondaparts....-exhaust-heater-fuel--taillight-license-light

Sponsored

 

[fitter_here]

Did you try to glue it in place with epoxy,?
It would be cheaper than buying a new tail light

Good luck

 

[Phy]

looks like it might screw out, it's definitely replaceable, just figure out how.

 

[Dauragin]

I broke a white pin/clip while trying to replace one of the bulb in my right tail light. Is this part replaceable or do I need a new tail light?
I can't figure out which part this is.
https://www.collegehillshondaparts....-exhaust-heater-fuel--taillight-license-light

Were you able to get one of these? I just replaced LEDs for my back up light and had the same problem with one of the clips.

 

[BrandonSmith]

Did you try the dealership?

 

[rwsmith123]

You can’t buy this pin from the dealer for some strange reason.

Here’s my version that can be 3D printed:

https://www.thingiverse.com/thing:4685862

 

[romuhhhr]

You can’t buy this pin from the dealer for some strange reason.

Here’s my version that can be 3D printed:

https://www.thingiverse.com/thing:4685862

Have you tried 3D printing them? I might need some.

 

[rwsmith123]

Have you tried 3D printing them? I might need some.

Yep, worked fine if printed so it’s laying on the side, if printed in the direction where it’s standing up it won’t be strong enough.

Sponsored