Blown 4th Gear?

[ValkenDnB]

I belive Eman posted that he also had PPG speedometer correctors or whatever the other day on his instagram. Had NA Performance engraved on the box so I'm guessing it's something he might have done in house.

Sponsored

 

[hobby-man]

I belive Eman posted that he also had PPG speedometer correctors or whatever the other day on his instagram. Had NA Performance engraved on the box so I'm guessing it's something he might have done in house.

I believe it's just one of those standard speedo correction boxes. The great thing is it is plug and play so you don't need to splice into your factory harness.

 

[Kotaas]

I belive Eman posted that he also had PPG speedometer correctors or whatever the other day on his instagram. Had NA Performance engraved on the box so I'm guessing it's something he might have done in house.

Yeah he finally finished his plug and play kit. It’s 500 shipped I’ll pass haha can’t beat plug and play but I’ll just take it to the car shop that always hooks me up. I can try convincing him to see if he’d be down to make kits depends on how many people want it

 

[websitesdown]

Yeah he finally finished his plug and play kit. It’s 500 shipped I’ll pass haha can’t beat plug and play but I’ll just take it to the car shop that always hooks me up. I can try convincing him to see if he’d be down to make kits depends on how many people want it

It cost me $120 to do what I just did, that's nuts.

 

[Kotaas]

It cost me $120 to do what I just did, that's nuts.

That’s what I’m saying $100 for the box $200 for kit and an extra $200 for the engraving In all seriousness I’m sure the quality and stuff is great but 500 for that kit is too much for me PERSONALLY. Hard pass for me lol

 

[kshawn]

Eman charges his prices because there's a market that will buy. Lot of people like plug and play. The less thinking the better lol

 

[hobby-man]

Eman charges his prices because there's a market that will buy. Lot of people like plug and play. The less thinking the better lol

$300 would have been my upper limit of convenience personally. I'm no stranger to splicing wires so it would be DIY for me when (if? ?) my trans pops.

 

[kshawn]

$300 would have been my upper limit of convenience personally. I'm no stranger to splicing wires so it would be DIY for me when (if? ?) my trans pops.

Have you also noticed all the trans threads?!

 

[hobby-man]

Have you also noticed all the trans threads?!

I put my horse blinders on lol. Don't even want to think about it while my engine is in pieces ?

 

[ChefRyeSi]

What do we think the limit is on the Si gearing? im planning on building the block and upgrading turbos but if i have to then spend $6k+ on gearing/install then its going to not be worth it

Sponsored