Donk232
Senior Member
- First Name
- Greg
- Joined
- Dec 22, 2017
- Threads
- 13
- Messages
- 73
- Reaction score
- 25
- Location
- Jacksonville Fl
- Vehicle(s)
- 2006 civic si-sold, 1999 crv-sold, 2014 crv, 2017 civic si
- Thread starter
- #1
I wrapped the turbo inlet and intercooler cold side pipes. Not really sure if the ic tube was helpful or not.
Then I added a 3" tube on the bottom of the air box into the fog light zip tied it in place.
finally I decided to cut the holes in the fog light vent to match the passenger side. I'm not totally done finishing off the holes but that's the idea at least.
None of these ideas are new and based on others' results I expect lower IAT, is there anything I should change or add?
thanks!
Then I added a 3" tube on the bottom of the air box into the fog light zip tied it in place.
finally I decided to cut the holes in the fog light vent to match the passenger side. I'm not totally done finishing off the holes but that's the idea at least.
None of these ideas are new and based on others' results I expect lower IAT, is there anything I should change or add?
thanks!