2020+ no grill front license plate mount

[Dejavu]

With the revamped front for 2020, I believe some of the no drill license plate mount suggestions are not viable. So I am wondering what you guys have been using for no drill license mount.

I actually bought one from someone on this forum but I was unable to mount it (I am not sure if I am technically insufficient or it's meant for 2019 or before).

Sponsored

 

[JDM Power]

My 2020 european model came with a shaped holder already installed from the factory on the front bumper, and all I had to do was to install the number plate frame on that holder.
Of course, the dimmensions of the holder is addapted for the european number plate model.

 

[EPSi2FKR]

My front license plate is in the trunk of my car. I’m not doing anything with it until I have to. I live in North Texas and haven’t been bothered yet! (Knock on wood)

 

[quitethechoi]

I bought this:

https://ansixauto.com/no-drill-front-license-plate-holder-honda-civic-type-r-fk8-2017/

I haven't used it but seems like a good no drill solution. The build material is really sturdy.

 

[Byron Sexton]

I bought this:

https://ansixauto.com/no-drill-front-license-plate-holder-honda-civic-type-r-fk8-2017/

I haven't used it but seems like a good no drill solution. The build material is really sturdy.

I have and it works and looks great just have small finger people helping you

 

[Beavis]

I used a squared “U” shape bracket with nuts, bolts and washers that I picked up at my local hardware store. The bracket is mounted to the honeycomb grille using washers to “sandwich” the two pieces together.

 

[Res0zsfa]

https://www.civicx.com/forum/threads/2020-type-r-license-plate-relocation.51414/page-2#post-935419

 

[Dejavu]

https://www.civicx.com/forum/threads/2020-type-r-license-plate-relocation.51414/page-2#post-935419

I actually have the same thing as well (except I tried to mount it in the middle). It is great solution but it seems to tilting forward and I am looking for something that will stay relatively close to the bumper.

 

[Res0zsfa]

I actually have the same thing as well (except I tried to mount it in the middle). It is great solution but it seems to tilting forward and I am looking for something that will stay relatively close to the bumper.

ohh, i didn't know that. I have it on the side where the mesh is stronger so it doesn't lean forward. probably not a good option then if you want it in the middle

Sponsored