lowering springs

Anyone running D2 springs with stock wheels ? Trying to see if I should run spacers with them or not

Currently running stock with 18x9.5 offset +35 with tires size 255/35ZR18XL and 15 mm spacers. And I’m considering on getting lowering springs and make the car lower by a little bit. I’m wondering what’s the best/safe thing I should do.

Hey does anyone have experience driving in the winter with lowering springs? I’m thinking of getting them come spring time however during the winter i am concerned on how it will handle, I’m in the northwest area of PA

Help, just installed new d2 lowering springs on my 2018 si, and the passenger side is about half an inch or less higher than the driver side. Is this normal? Or did I miss up

I have a brand new set of Eibach Pro Springs I bought from MAPerformance. I decided after installing side skirts and barely getting a jack under my car that stock suspension is low enough for me. These have never been taken out of the box. Please check part num Currently $350 new on...

Looking to sale my set of set of Eibach Sportline Lowering Springs. Fits all 10th gen platforms excluding the Si and the Type R. Honestly enjoyed running these, very comfortable setup. $170 OBO Local Pickup Los Angeles/Orange County

Hello, I am new to the lowering scene. I just bought Eibach sportline lowering springs and I am looking ahead in terms of tires. I want to go wider so I am looking at 245’s right now. I was curious if going with a 40 sidewall would create more rubbing than the slimmer 35 SW. The wheels I...

So I finally got these springs put on my pretty much stock car. I found out about these springs from the master spring thread on here and saw that it was the lowest drop I was going to get from springs. About a 1.6 inch drop all around. I made sure the shop put on the included bump stops that...

I am installing lowering springs and I am unable to get the ball joint back into the LCA on the front right side. I got the strut in, then put it on the spindle unbolted from the LCA, but now the LCA can’t reach the ball joint. This is my first time really doing any suspension work on any car so...

I jumped the gun buying these. I had plans to lower it after I got my wheels but the wheels on stock suspension look good imo. The biggest reason is the roads I have to drive on though. So they’ve never been used and still in the box. I’m asking $170 to ship.

Hey all! I splurged a bit with my tax return and bought a few suspension components and have a few questions: Whiteline Front (27mm) & Rear (22mm) Swaybars w/ endlinks D2 Lowering Springs SPC Rear Camber Arms I'm going to get my car up on the lift and install all at the same time this Sunday...

I have a 2018 civic lx on stock suspension currently sitting 4 inches from the ground due to my side skirts. I was wondering whether I should lower 1 inch or 2 inches, and if there are any issues I could run into while doing so? The 1-inch drop would most likely be the more beneficial decision...

Curious to see if anyone has done this or knows someone who's done this. I'm running some super grippy 255/35 Nittos on my stock rims (I like the look) and I still think theres plenty of room for lowering springs to compensate for the increase in ride height. Thoughts?

I have a brand new set of FK7 Eibach Lowering springs for sale. Bought them for the civic about 2 months ago, but the opportunity to buy an LC fell into my lap. Springs are brand new, but the box has been through a rough patch in its life. I will ship them in a different box. $160 shipped. And...

Whats up honda fam need some help. Just installed D2 springs on my SI and after the job was done I only had two pieces of the bump stock we cut off the front. We forgot to do the rear because we were able to swap the spring without removing the strut. I only drove around about 20 miles since the...

I have been planning on getting D2 lowering springs for my 2018 Civic SI Sedan but i'm concerned about the negative camber that comes with lowering any car. I was planning on getting a rear camber kit but I want to know if it is really needed. Is the camber so bad that it wipes out tires, and...

I am new to this platform and forum and had run into troubles trying to find lowering spring info and options for the 10th gen SI (FC1/FC3) so i decided to create a master thread dedicated to the SI specifically like the one that exists here for the Type R (FK8). Another good reference thread is...

FOR SALE- is a set of brand new in box Eibach Pro Kit Lowering Springs (for 17-19 si- may fit the 20 model but I have not verified. I would make sure before purchasing if you own a 2020). Only opened the box to look and make sure everything was there and in good shape. Price: 170 local...

Hello, first let me say thank you to this awesome community. I read the forum posts and learn a lot along the way. Back a couple months ago purchased a set of D2 Lowering Springs. I was holding off on the install until I had to do my clutch so I could do both at once. I have recently ordered...

Selling Eibach Pro kit lowering Springs New unused . Just opened the box . asking $200 shipped