camber

Hello guys, I'm in a little bit of a dilemma. I recently switched to HKS Hipermax S coilovers which do not come with camber plates, so I'm not able to get more than -0.5 degrees in the front. My problem here is even if I did get whiteline camber adjustments it would only give me an extra degree...

Forgot I still had these, the previous buyer backed out. A BNIB set of SPC Performance Rear Camber Kit/Adjustable Control Arms for 2016-2021 Civic, will not Type R. You can adjust camber up to + 3.0 degrees with this kit. Prefer a local buyer to the Orange County, CA area that can meet up...

Stayed 5 hours after work last night and put new Ktuned camber arms and swift si springs on my fk7 sport. I only wanted a small drop not too much as I have prl cobra and it rains a lot in FL cut the bump-stops a tad and liking it soo far. New wheels and tires + alignment in the next 2 weeks

So I finally got these springs put on my pretty much stock car. I found out about these springs from the master spring thread on here and saw that it was the lowest drop I was going to get from springs. About a 1.6 inch drop all around. I made sure the shop put on the included bump stops that...

Selling new never used Eibach Rear Camber Arms. One of the packages was opened for inspection. $300 shipped in continental US. Thank you

Looking to pick up the SPC Rear Camber Kit preferably from someone in Socal. Im willing to have the camber kit shipped over to me if the shipping price is reasonable. Let me know, I need this part as soon as possible. Reference Photo Listed Below

I'm not sure how many people have tried pushing more camber from their coils, but I hope this helps I've been trying to figure out how to get more than -2.5 degrees on bc coils for the front struts, as many know, any coils for the hatchback(except type r) do NOT have extended camber plates and...

I have a set of brand new EVS Camber joints. I ended up not needing them so these are for sale. I’m asking for $200 and am willing to ship as long as you pay that shipping fee.

So I just installed H&R lowering springs ( 1.25 drop in front and 1.0 drop in rear) and Godspeed camber arms in the rear. So I went to go get aligned and when I drove off I saw that the rear tires have a -3.2 camber. It seems very aggressive to me for being a street only daily driver. Do you...

I have a 2020 Civic Si Coupe and have the Eibach Pro Kit lowering springs on the way. Do I need to install anything else along with the pro kit such as a camber kit, spacers, etc? Also, how necessary is an alignment and should it be done after the springs have settled? My car is stock. Is...

I have been planning on getting D2 lowering springs for my 2018 Civic SI Sedan but i'm concerned about the negative camber that comes with lowering any car. I was planning on getting a rear camber kit but I want to know if it is really needed. Is the camber so bad that it wipes out tires, and...

Hello, first let me say thank you to this awesome community. I read the forum posts and learn a lot along the way. Back a couple months ago purchased a set of D2 Lowering Springs. I was holding off on the install until I had to do my clutch so I could do both at once. I have recently ordered...

So, I recently got some 18x9.5 with a +15 offset on 235/40/18. It doesn't rub unless I have a full car and it only runs in the rear. Should unroll the fenders and get a camber kit to help with this? Do the wheels look silly? It pokes out a hair. I can post more pics on the morning

Looking to purchase the sportline springs (look better than the pro-kit) and the rear camber arms if you have them! If you have them pm me or post. Located in FL, so willing to travel or pay for shipping.

I got off work today and the rear wheel on both side are tilting inward on top (negative camber) I am not too sure about the factory setting and stuff. Does anyone have any advice or recommendations? i have civic LX running 6700 km on factory tire and wheel

Does anyone know what the camber range is for the 2017 Civic hatchback sport? Looking at http://www.civicx.com/threads/front-camber.6357/, it appears that crash bolts may not work. I'm not planning to run plates since I want to compete in H Street in solo . . .

After putting the SI rims, i noticed that my driver rear tire was tilted in. I went into a small auto shop to get a reading (attached image) -- I wouldnt have noticed this if i didnt put in the SI wheels. I already set an appointment with the dealer to get this fixed. Should i put the stock...