I have the Hertz C26 are a direct fit and easy to install with the supplied clamp but you will need to sand the opening on the sail panel ever so slightly to clear these bad boys.
I went with these because they were a decent brand, available here, not too expensive and IMHO have an OE look...
Hi mate, the tweeters would be a bigger difference compared to the center speaker but all still worth doing. I am still running the stock woofers in the front doors. Pretty happy with the setup now.
I didn't use any baffles because they are almost impossible to find here. I think you could...
Congrats on your new car Nate.
Found a lip here. Despite the description saying it is for a hatch, the front bumper is that of the sedan.
For an exhaust, there is a magnaflow and HKS one that will fit but they don't look good because they stick out below the rear valance. Magnaflow one can...
As long as the used KTuner is unlocked, you should be able to use it on a supported model with a supported ECU. I believe CTR ECUs need to be unlocked(?) so best check on the CTR forum or contact @KTuner.
Hi Dimmy, I assume you meant to ask about the tune used.
In short, any of the tunes included will work. If you have no experience, start with any of the stage tunes. Otherwise, you can use the starter tunes which will allow you to tweak or customize to what you want but be sure to know what you...
Update #1
Vehicle: 2016 Civic VTI-LX CVT Sedan (Touring equivalent in Australia)
Total tuned time: 46+ months
Total tuned mileage: 45,000+ km
Tuning device(s) used: KTuner V1, currently using KTuner V1.2
Tunes used: Custom VitTuned E10, KTuner base tunes, currently using custom VitTuned E35...
Greetings from Down Under and Happy 2022!
I have been monitoring the CVT temperatures on Tunerview on my phone via KTuner V1.2. However, I recently noticed the CVT temperature stays constant at 67 deg. C even right after a cold start (ambient temperature about 25 deg. C) which cannot be right...
Anybody from Australia installed the brace?
Just tried on my 2016 VTI-LX (1.5T) and the holes are not threaded. It turns out our Civics (from Thailand) have a different subframe to the ones from the U.S.
Metal brackets only for C26.
That is a substantial price difference, it was not that big for me here in Australia. I cannot say if it is worth it but the C26 does fit and look better IMO.
Yes, those harnesses should be plug and play if they fit the factory connector. There's another thread on...
No mod necessary. The speaker was a snug fit but it did fit to the plastic speaker cover. I used some foam tape to help with sealing the speaker to the cover and to stop any rattling.
I like the ones I put on - Hertz C26 Cento tweeters. They sounded great, looked good and were easy to install to boot.
Check out a photo of the install bracket here.
I felt the stock tweeters were really harsh compared to the Hertz ones I put in.
If you are not keen to change out the...
I did not use the crossovers.
FYI, I actually went with Hertz C26 Cento tweeters instead of the Hertz DT24.3 tweeters. IMHO, they look way better and are also much easier to mount with the included metal brackets.
For the center speaker, I went with the Hertz DCX87.3 Dieci speakers.
Suggest you do it in incremental steps and stop when you are satisfied. I started with tweeters and sound dampening on the front doors. It was a good improvement already but then I did the centre speaker too more out of curiosity than necessity and I thought that was better. I also installed...