Search results

There’s been a lot of drama coming up in the threads by @Awdfk8machinist , also known as Stephen Dunn at AKD Built Performance. Some members have suggested moving this to a separate thread to discuss, so here it is. I know many of you are already subscribed to my channel where I am documenting...

I have a really strange leak I’m wondering if anyone has some insight on. I finally finished my swap and noticed a leak between the engine and trans. I pulled it apart and there was little fluid but it seems as if it’s coming from the flywheel bolts. The threads seem to have a closed end so that...

I started the k20c4 swapped si for the first time today! It runs but there’s this strange oil leak on the head of the motor it looks like it’s coming out of these openings that have balls in them?

https://www.yonaka.com/product_p/ymar-ctrfk8.htm Skeptical of the quality but I’m looking for a fan and rad design. Any information is greatly appreciated

Anyone else run into this issue? Thinking about either hammering the tunnel or putting the eye bolt through the tunnel instead of the seat bracket.

I'm installing seats and 6pt harnesses in a sport hatch for a friend. All parts were provided by him. My questions are primarily regarding the wiring. I have a 2ohm resistor for the airbag wire and I was planning on removing the seat buckle from the original seat and plugging that in. For the...

Im doing walnut blasting in the intake valves of my k20c4. Does anyone know if there is an adaptor piece for the air nozzle and vacuum to connect to the intake?

Here's a link to the first video in my series on k20c4 swapping my Si. :spaz:

Looking for an aftermarket type r frontpipe

I'm aiming for 400whp by the time I'm done with this swap. What clutch options would you recommend? How is the oem flywheel? I was looking at the ACT kit but I'm curious if the upgraded flywheel is really that beneficial over say just a clutch and pressure plate with the oe flywheel.

Has anyone locked vtec on their exhaust cam? If so, where can I find the pins?

Does anyone know if this downpipe is any good. Seems cheap but I wanted to see if anyone has experience with it.

Anyone know if the trac spec hood vents for a type r will fit the si hood?

This hurts

I have a question for those running any bbk. I have the genesis coupe bbk and I feel like there is too much brake bias in the rear. I’ve been noticing that the rear brakes always have more dust than the front (same pads). More importantly, under really hard braking on track the rear end seems to...

The black cam inspection cover at the top of the motor has been leaking ever since I replaced the head gasket (I know I shouldn’t have reused it). Does anyone have a part number?

I just installed my skunk2 exhaust and I am now hearing a very loud rattle coming from the rear, mainly in the rpm range where there’s drone so around 4k. The rattle doesn’t seem to be coming from the exhaust itself but actually the taillights. Has anyone else expiernced this? Maybe new hangers?

I need help diagnosing my car. Fbo, e30, rv6 turbo. I noticed that my car was sputtering when I left this morning. I thought it was either the head gasket or bad fuel. Found no leaks, no codes, normal temps, fuel trims, and knock control. I had a quarter tank and filled it with Sunoco 93...

If I only change the drivers seat and wire in a 2.2 ohm sensor, will the airbags still deploy normally in an accident?

Over the winter, I bought a new set of wheels and tires that I was planning to use for track and autocross. In the pursuit of having the most grip possible, I went a little overboard. 18x9.5 +40 with a 255 40 tire is just too big. My friend told me “a blind man could have told you those wouldn’t...