Go with the 3" for both down and front pipe. Also get solid rear motor mount. The pipes actually make quite a difference in the way the car sounds as well. At least I think so
I hear ya on aftermarket clutch and flywheel. I have a stage 4 clutch masters and clutch masters light weight flywheel. Only reason I went with stock free replacement was because well I don't have the 1000 dollars to install the badass one lol.
I can understand that. Doesn't hurt to try though. The service advisor I dealt with didn't even hesitate. I told him my mileage I am under warranty. I left the car with them and he called me 4 hours later and said hey I have great news, we are going to replace that clutch for ya. $0.00. Just do...
Sometimes it means free parts and you pay labor. I'm an outboard technician at a large marina and that's what we usually do anyway if the motor is out of warranty. Me on the other hand I am still in warranty with less than 36k. So hopefully everyone gets in. The TSB is only for years 20-21...
I wanna say a service bulletin or TSB is there for anyone either within or out of warranty. The guy did ask me how many miles were on the car so that leads me to believe that there is most likely some sort of milage cut off point but idk 🤷♂️ for sure. I got sick of my clutch being so terrible...
I am picking the car up today or tomorrow, had them replace the windshield also, through insurance... I'll get the tsb from them then and get back to you.
Not sure if anyone out there knows this or needs to hear/read this but honda has a new service bulletin out for all civic ex, sport and SI models equipped with manual transmission of course, that states premature clutch wear. You will get your clutch, flex plate and flywheel replaced for free. I...
I know this topic has probably been exhausted but I'm just wondering what the best opinions for looks and functionality for a front lip/spoiler for my 2020 si sedan.
So very simple question. Has anyone taken their 10th gen to your local Honda dealer for any type of drive train warranty work with your pcm flashed/tuned/not stock and had any issues? I am hearing a slight whine or humming noise while under load through 1st and 2nd. I think it is the imput shaft...
So i bought some Chinese specials splitter rods off amazon for like 15 bucks. BAD DECISION. Had to pull the bumper off and it was bitch. Long story short the hardware rusted to shit after about 3 weeks fml. Trying to find some good ones that use full billet aluminum and stainless steel hardware...