Search results

I got the roof of my car vinyl wrapped about 4 years ago and last year it started cracking badly. I finally have the time/budget to remove it, but the shops near me are (understandably) quoting >$700. I tried scraping it with a plastic razor in the sun, but it's slow going. The paint underneath...

Bought it and used it for a month a while ago, been sitting in storage since. $40 local to 91201, $50 shipped.

While vacuuming my seats I noticed that the stitching where the seatbelt reaches over has been cut up and the fabric is starting to tear: Is anybody else having this issue? Should I just superglue this gash up or would Honda warranty something like this?

I took my car into a local shop for an alignment and they noticed that the right axle boot tore. I took it to the dealer and they recommended to replace the whole assembly, and they said that it's not going to be covered, as the Honda Limited Warranty only covers 3 years/36k and I'm at 3 years 1...

I recently took off my Eibach Pro-Kit and went back to stock suspension, but when I was putting air in my tires, I felt a little lurch from my front-left side and it felt like the tire rubbed against the inner fender. When I was leaving, I took a sharp left and again it felt like there was a...

The roads have gotten increasingly worse on my daily commute so I went back to stock. These were used about ~40k miles, but all looks fine. $80 local pickup in SFV, can ship at buyer's expense.

Upgraded to a CTR Shifter + Acuity Stage 2 kit + Poco Knob. Just trying to get rid of this to make space. $50 shipped.

Heyo, so Im going back to the stock springs but Im stuck with trying to put the LCA back on. The top nuts are done, and the nuts underneath the arm are fully on just so the whole assembly doesnt pop off the actual arm. Ive tried wiggling it, rubber mallet, WD40, it just doesnt want to go in...

Selling my Ktuner v1.2 - $250 shipped. Unlocked, comes with Phearable Stage 1.5 Tune (although I believe the tune may only be configured with 27Won CAI)- Sold!

Selling some shift knobs that were both used for less than 3 months each. I bought these and tried them out and found that the Ashiko was the one that worked for my hand and grip the best. Vision: $50 Apex R: $25 Extender: $20 Please Note: You will need the Raceseng M10x1.5mm adapter and the...

I've had my Si for about a year now and I just noticed that there's a very noticeable creaking or popping noise at the end of my steering range. Usually when getting into or out of parking spots. Does anybody else have this noise on their Si? I'm wondering if this is normal or something I...

Been seeing these around lately and I don't know what to think of them. On one hand, the monochromatic looks is sorta cool, but they also bulge out a little weird. They also have GPS trackers on them to help against car theft, or to prevent even the plates themselves from being stolen. I'm...

Selling my PRL Cobra Cold Air Intake, with everything included except for the two screws needed to bold the MAF sensor into the housing. Used less than 5000 miles, comes with aFe Pro Dry S filter. $300 shipped.

I replaced my MTF today with Amsoil Synchromesh and when I was done, I noticed that there were some cracks on one side of the transmission case. There was nothing leaking through it, I checked after filling it up and after idling for a couple of minutes. Are these just imperfections in the...

I purchased the PRL SRI to CAI conversion, and I cant seem to get the MAF housing to fit snug on the two silicone pipes. I find that I have to jam the wide end into the pipe and it doesnt sit quite flush. The hose clamp is tightened really snug to the point where I cant shake the hose loose. I...

Selling the OEM Shift Knob from my 2020 Si. Used less than a week after purchasing the car, no blemishes. $60 plus shipping, OBO.

Replaced the stock rear sway bar on my Si Coupe, and I'm selling the stock Si one for $60 + shipping. Shipped with brackets, but not the hardware -- you will need to reuse your stock hardware or get new OEM ones.

I apologize if this has been answered in a separate thread, but I couldn't find a direct comparison of the two. I'm going to be ordering a rear sway bar soon to upgrade on my Si Coupe, and I pretty much have it down to either the Eibach 22mm, or the Progress 20.6mm. I don't do track, but I do a...

Forgive me if this question has been done to death -- I've found multiple threads on this across a dozen forums but haven't found a conclusive answer. I have a chance to pickup a Mishimoto intake for cheap, but I was wondering if I would run into any issues putting it on my car without tuning...

I've been seeing some Si's on IG that have the front badge changed to a white one. I wanted to get one myself but I can't find one available for the life of me. I tried painting it with enamel paint, and another time with spray paint, and both times the paint failed to stick to the red part of...