Search results

I know what you are talking about now. I will have to check that and make sure. I have whiteline springs, end links and front sway bar installed to the front end.

You’re talking about the 3 nuts that attaches the wheeL end to the lower control arm right? If it is that they were all torqued.

I tightened the top nut on the strut until It wouldn’t let me tighten anymore. One of my front end links were loose but took it apart and made sure it was the same length as the oem ones but still had the clunking noise. Do you know how much play should be in the ball joint?

Is anybody having these clunking noise? Load on the suspension and jumping up and down on the car caused it to make that clunking noise. No load on the car and on jack stands jumping up and down doesn’t make any noise. On low speed from 5-45 mph will have that clunking noise but on freeway...

Yeah everybody has their preference on what they like. I got it because it was more aggressive looking compared to an OEM bumper. I personally love OEM parts because they fit way better and you know it’s a genuine Honda part. One day if they make cut off fenders like Tracklifecomposites it will...

Here’s an update from the type r bumper i ordered from six degree carbon. Coming in from Malaysia took about a month to get to California. Putting all the plastic pieces on was kinda tricky had to lift up the plastic tabs and push it in until I heard it clip. I had to cut a little square where...

Sadly it will not completely solve the problem. I went to the dealer again and told them it was happening again after they replaced the brake shims. They told me that one of the main problems is if you are driving it hard braking and turning and sometimes bumpy roads constantly will start to...

I just ordered my Type R style front bumper from Six Degree Carbon in Malaysia. Everywhere else I’ve been looking at is sold out so I took the risk to order from them. Wait time he said was about 3 weeks to come to California via Air freight. Fingers crossed that everything goes well.

I just went to my local dealer and they already knew about the problem and replaced it under the limited warranty. Before I brought it to the dealer I had it happen again and hit it back in place and used silicon to stop it from moving again. I would recommend if you want it to be a quick and...

Whenever it starts doing that again I might have to consider sanding it down like you.

If you are still having that squeaking problem when turning this may be one of the issues. Those 2 brass looking clips that hold your brake pads in might have moved causing it to rub when turning. I just got a rubber mallet and hit it a little and it moved back where it is suppose to be. (You...