I installed mine when I had the center console apart to install the Type R shifter and all the Acuity goodies. I just fished the power wire through under the drivers side carpet, up to the center area, then through the passenger carpet to a hole. I grounded the amp on the bottom bolt for the...
I upgraded all 5 front speakers and added a Cerwin Vega powered under seat sub to the passenger side. It doesn't go as low as a full size box in the trunk, but it works for me. I tapped into the front door speakers for a signal to the sub.
I have the same setup and people keep telling me that my car purrs at idle or low throttle. It sounds much better than stock but isn't too loud and actually adds power.
I had the bolts, I just forgot to put them back in. They came out of the heatshield that didn't need to be removed. I guess you could look at a service manual to see what you are missing and get part numbers from that?
Nope, no issues at all, +38 brings them almost perfectly flush. I am still on stock suspension, but I have a set of Whiteline springs that I will install eventually.
Before I purchased, I did lots of reading in the wheels and tires section, messed with wheel and tire size calculators. I...
I purchased a wheel and tire package from TireRack. They mounted and balanced them and included the hub centric rings and new lugnuts and they were delivered to my door. TireRack has a large selection of wheels and if I needed another set, I wouldn't hesitate to purchase from them again...
I had a rattle after my RV6 dp/fp install also. I went back and checked all the bolts on the heat shields and I was actually missing the 2 that face the front of the car. Once everything was tightened up and I replaced those two bolts, no more rattle.
Heard on the news this morning that the refineries in Texas are having issues due to the cold snap that caused all the power outages. Until the refineries are back up to full capacity, there could be shortages.
I second what @Thusee said about the 2020 Type R shifter assembly. I installed that and the Acuity Stage 2 (for the Type R shifter) at the same time with the stock shift knob and the difference was amazing. Much shorter throw and it felt better than the manual linkage from my BRZ. I have...
I am running Indy 500s on my 18x8.5 Enkei TS-Vs. They are much better than the stockers and I haven't had any issues in the coldish rain that we get in winter.
Tirerack makes a wheel and tire combo purchase super easy. They took care of mounting and balancing, they send new lugs and the hub...
I did wheels and tires at the same time that I installed the TypeR subframe brace and flashed with kTuner.
Since then I have installed a 22mm rear sway bar and an IC.
I am currently waiting on the dp/fp and springs.
I run around town on Phearable map 2 and have not experienced my clutch...
If you are using the front speakers, use pins 5&6 for left and 12&13 for right. The image above of the pinouts is the terminal side, so you will need to reverse it when looking at the plug you pull out of the amp, or just look for the colors referenced in the chart. They matched on my 2020 Si...