My 2017 civic ex bleed screws are rusted. They never been changed. This wrench the best way to remove the bleeder screws without stripping? How does it work vs a wratched socket or regular rench?
Is it necessary though these PIAA horns only pull 2.7 amps per horn, so would existing wiring handle two or three of these horns on the same existing power line?
For the dual Wolo high/low setup how did you wire ther horns? Did you run a relay for the seond horn addition?
Believe each Wolo horn is 5 Amps, would two 5 amp horns be okay on the original horn civic circuit?
For the dual Wolo high/low setup how did you wire ther horns? Did you run a relay...
Can you connect 3 x piaa horns one original 10th gen civic horn wire? Believe each piaa horn is rated a 2.7 amps.
Found this adapter splitter which should work. Or is a relay needed?
ali express harness splitter for cicic
Have a 10th gen EX civic, are you using all three horns on the original wiring for the single horn?
Believe the PIAA are 2.7 amps each so 3 x 2.7 = 8.1 Amps. That good enough with OEM wiring?
Found this adapter splitter which should work. Or is a relay needed?
ali express harness splitter for...
Looking at a set of wolo horns, each is 5 amps. You think the 10th gen 2017 civic horn wiring can handle the 10 amp draw for the two horns?
Found this adapter splitter which should work. Or is a relay needed?
ali express harness splitter for cicic
Looking to get a set of horns, low and high to replace original. What sort of relay would I need to get? I'm looking at different horns than was posted by original poster.
Hi,
I add about half a quart or (500ml) oil between oil changes as car burns some oil. Would this car be considred high mileage now? Would you still be using 0w20 full synthetic oil, or would you switch to something thicker?
Cheers,
rev
My civic 2017 civicc EX has 105k miles on it, bought it when it had 20k miles, about 4 years ago. Never swapped the CVT transmission fluid. Should I go ahead and swap the fluid. Read somewhere, when it is not changed for a long time, it should be left as is?
regards,
rev
Believe I've cleaned all the rust out, but I'll take it apart again and check.
Is there any wobble tolerance to the bearing assembly? The wobble is visible to the human eye, I'd assume that's a bit much? But the sound is strange.
I'm going to lift the back end of the car, and compare the two...
Hi Folks,
Have a 2017 civic ex with about 170K km on it. I swapped the rear brake pads for new ones, as those were finished. Can I pass safety with what is left on the front brakes or should I swap the front also?
Front passanger pad has about 4.5 mm left on it.
Front passanger rotor photo...
Hi Folks,
I was working on my brakes and noticed the rear driver bearing is making noise. Here is the video.
Can you recommend any fair and honda knowledgeable shop? The dealer wants $542+tax to relace one bearing.
Hi Folks,
Just working on my car doing my rear brakes. Did the passanger followed by the drivers side. Notice the drivers side is making noise and has a very slight wobble where it rubs against the new brake pad.
Bearing video.
Here is the wobble of the rotor. Could the rotor be intalled...