So this happened to me today. I went to start my car and it seemed to struggle turning on like @joshkim993 experienced. Behold I check the engine bay and the same wire has been chewed on.
I am taking the car to the dealership tomorrow morning because they didn't have any available openings for...
Stock setup - 215/50/17
Winters - 205/65/15
My car is an EX-T coupe lowered on eibach prokit.
With the diameter the same, will downsizing to the 15s make the car any lower? And would there be any issues?
so im having this issue now but im connected to my desktop computer. i didnt have any issues before until today.
the ktuner unit doesnt even turn on when connected to the OBD port on the car. when i try to launch the ktuner application on my computer it doesnt even ask to login anymore it just...
There have been many threads about this.
Your idle RPM is most likely at 620-ish (considered to be low) which is the symptom causing the vibrations. To remedy the vibrations, you can either turn the lowbeams on, OR turn the rear defroster on, OR turn the AC on, which will bump the RPM back up...
Green - screw hole
Red - nipple hole 1
Blue - nipple hole 2
The paddle shift will have 2 nipples;one that goes into blue and one into red and then a single screw that goes through the green to hold the paddle shifter in place.
The buddy club wheel does not have one of the red or blue circled...
The paddle shifters are part of the wheel. They have 2 small locator nipples and is mainly secured and held on with 1 screw. You'll have to cut off one of the nipples, takes less than 5 seconds.
Everything works without issues and fitment is perfect (exception for cutting off the small locator...