Hello,
Im trying to fit the bottom of the coilover into the knuckle. Iām really close but canāt get it to go in all the way.. can I spray wd40? And once thatās in is it easy to put back tbe LCA nuts?
Thanks
Used for 48k miles. fenlab ceramic coated initially.
$500
Pickup. Fort Worth TX
or shipping
includes 4 wheels and lugs + 4 extra and lug key.
shipping to cali:
Fedex $307.52
shipping to florida:
Fedex $237.88
spacers are not included
Used for 48k miles. Ceramic coated initially. 20/25mm spacers looked good on the coupe not sure how they look on others. I included pic for ref. Always torque spacers to spec.
700 w/ spacers or 600 without.
Pickup. Fort Worth TX
includes 4 wheels. spacers+nuts. 20 lugs + 4 extra and lug key.
Hello,
I like the look of my flush 20/25mm spacers front rear on 2020 stock wheels. Iām a noob on wheel specs. Would 18x8.5 +45 offset be the same fit and clearance as stock wheels and can run with spacers?
Or should I ditch the spacers and get something that will clear bbk w/o spacers? Also...
Hello,
I have the caruse v3 aero flap. Since Iāve installed it, Iāve noticed more cracks and even a small dent right under the center of the light bar. I ordered the HIC rear windshield visor to help mitigate. Not saying itās the caruse but I did start noticing this post install.
looking a...
Hello,
Iām thinking about re-doing this stencil paint on my prl intercooler. It looks bad. What do yāall suggest to prevent this from happening again. I want it to last forever so I never have to take this bumper off again.. Iām looking at charge pipes because if Iām taking the bumper off, I...
Hi,
Im at 60% oil life and 43k miles. Tuned for 35k. Always done 3.7 quarts on oil changes. Never added oil before. Itās been sitting cold for about 12 hours.
What do you think? Should i suck it out to see dry spots on the stick? My chevy is so much easier to read and iām always adding oil to it..
Hello,
I have these swift spec-r springs, but I haven't gotten them installed yet. I'm looking at spacers and getting it all installed at once with an alignment. I don't want to trim my studs. From research, I'm looking at 20/25 front/rear spacers. Any other recommendations? Also, i'm on stock...
2020 civic si coupe daily driver.
should I lower or na?
I want to keep adaptive dampers, so looking at springs. I Just want a small drop. I've read Swift Spec-R are the best because they're stiffer so they're for strut life.
I'll be installing them myself too. Never done it before, but I...
Hello, I have an issue with my HVDP it wonāt fit because the heat shield is hitting that cable bracket Iāve tried many ways @PRL Motorsports
Edit: I got it. Weāre good had to hammer some stuff to fit but weāre good
Hello, I was cleaning my car and found that my drive side floor is uneven. Thereās this hard bump on the right side. Here are pictures. Is this normal? Iāve jacked it from the front jack point before. It was done properly so this is weird.
PRL high volume downpipes upgrade
Says it'll be available in June. I just want to make sure I'll be getting the right one. I have MAP cat back and MAP front pipe. I've found information on other downpipes but they don't seem to be relevant anymore because of error codes and CEL's.
Thank you
Hello. I found a leak under half shaft bearing and got warranty replacement shaft assembly but it still making this noise.
Could they have replaced the shaft without the bearing? I looked up the part number it says it includes the bearing.
Itās not my bag. The noise is coming from under the...
I'm hoping someone can recognize this noise.
I have MAP exhaust, and PRL CAI
It's been happening a while now. I notice it more at the drive thru . It's not just when im turning. It's also when im going straight. If its the exhaust I just dont see where the exhaust could be making that noise.
I hear the noise from the pump, but today it just wont squirt. Not sure how to check fluid levels. Ive had the car 12k miles now from brand almost a year.
Edit: no light came on so wondering what it could be
Edit: filled it up works fine. thanks yall